xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
287
rip - To redistribute RIP routes to BGP.
ospf - To redistribute OSPF routes to BGP.
all - To redistribute both OSPF AS-internal and OSPF AS-external routes to BGP.
internal - To redistribute only the OSPF AS-internal routes.
external - To redistribute only the OSPF AS-external routes, including type-1 and type-2
routes.
type_1 - To redistribute only the OSPF AS-external type-1 routes.
type_2 - To redistribute only the OSPF AS-external type-2 routes.
inter+e1 - To redistribute only the OSPF AS-external type-1 and OSPF AS-internal routes.
inter+e2 - To redistribute only the OSPF AS-external type-2 and OSPF AS-internal routes.
metric - (Optional) Specifies the BGP metric value for the redistributed routes.
<value 0-4294967295> - Enter the metric value used here. This value must be between 0 and
route_map - (Optional) Specifies a route map which will be used as the criteria to determine
whether to redistribute specific routes.
<map_name 16> - Enter the route map name used here. This name can be up to 16
characters long.
no_route_map - Specifies to withdraw the route map setting.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To add route redistribution settings:
DGS-3620-28SC:admin# config route redistribute dst bgp src ospf all metric 2
Command: config route redistribute dst bgp src ospf all metric 2
Success.
19-10 show route redistribute
Description
This command is used to display the route redistribution settings on the Switch.
Format
show route redistribute
Parameters
None
Restrictions
None.
To Next Page
Loading...
Need help?
General