D-Link xStack - Page 357

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
352
Example
Configure access list debug flags’ state to enable:
DGS-3620-28SC:admin# debug bgp access_list enable
Command: debug bgp access_list enable
Success.
DGS-3620-28SC:admin#
Output Examples: After configure BGP to enable access list debug flag, it may print following
information when access list applied.
access_list:<ac1>,apply bgp neighbor:<19.0.0.1> MATCH.
21-55 debug bgp prefix_list
Description
This command is used for setting prefix_list debugging flags to disable or enable. If this flag is
enable, prefix list permit or deny in BGP module will be displayed.
Format
debug bgp prefix_list [enable | disable]
Parameters
enable - Enable the prefix_list debug function.
disable - Disable the prefix_list debug function.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure prefix list debug flags’ state to enable:
DGS-3620-28SC:admin# debug bgp prefix_list enable
Command: debug bgp prefix_list enable
Success.
DGS-3620-28SC:admin#
Output Examples: After configure BGP to enable prefix list debug flag, it may print following
information when prefix list applied.