D-Link xStack - Page 358

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
353
Prefix_list:<list1>,apply bgp neighbor:<15.0.0.1> MATCH.
21-56 debug bgp state
Description
This command is used to set the global state of BGP debug function.
Format
debug bgp state [enable | disable]
Parameters
enable - Specifies to enable the debug function of BGP.
disable - Specifies to disable the debug function of BGP.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
To enable the debug function of BGP:
DGS-3620-28SC:admin#debug bgp state enable
Command: debug bgp state enable
Success.
DGS-3620-28SC:admin#
21-57 debug dhcpv6_client state enable
Description
This command is used to enable the DHCPv6 client Debug function.
Format
debug dhcpv6_client state enable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.