D-Link xStack - Page 363

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
358
console - Let the debug message output to console.
Restrictions
Only Administrator-level users can issue this command.
Example
To set debug information to output to console:
DGS-3620-28SC:admin# debug dhcpv6_relay output console
Command: debug dhcpv6_relay output console
Success.
DGS-3620-28SC:admin#
21-65 debug dhcpv6_relay packet
Description
Used to enable or disable debug information flag for DHCPv6 relay packet, including packet
receiving and sending.
Format
debug dhcpv6_relay packet {all | receiving | sending} state [enable | disable]
Parameters
all - (Optional) Set packet receiving and sending debug flags.
receiving - (Optional) Set packet receiving debug flag.
sending - (Optional) Set packet sending debug flag.
state - Specifies if the designated flags function will be enabled or disabled.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled DHCPv6 relay packet sending debug:
DGS-3620-28SC:admin# debug dhcpv6_relay packet sending state enable
Command: debug dhcpv6_relay packet sending state enable
Success.
DGS-3620-28SC:admin#