D-Link xStack - Page 364

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
359
21-66 debug dhcpv6_server packet
Description
This command is used to enable or disable the debug information flag of the DHCPv6 server
packet, including packets receiving and sending.
Format
debug dhcpv6_server packet [all | receiving | sending] state [enable | disable]
Parameters
all - Set packet receiving and sending debug flags.
receiving - Set packet receiving debug flag.
sending - Set packet sending debug flag.
state - Specifies the state of the designated flags.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled the DHCPv6 server packet sending debug:
DGS-3620-28SC:admin# debug dhcpv6_server packet sending state enable
Command: debug dhcpv6_server packet sending state enable
Success.
DGS-3620-28SC:admin#
21-67 debug dhcpv6_server state disable
Description
This command is used to disable the DHCPv6 server debug functions.
Format
debug dhcpv6_server state disable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.