D-Link xStack - Page 371

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
366
Prompt# debug show status module MSTP
Command: debug show status module MSTP
Debug Global State : Enable
MSTP : Enable
Prompt#
To show the debug state:
Prompt# debug show status
Command: debug show status
Debug Global State: Enable
MSTP : Disabled
IMPB : Disabled
DHCPv6_CLIENT : Disabled
DHCPv6_RELAY : Disabled
OSPFV2 : Disabled
VRRP : Disabled
RIPNG : Disabled
ERPS : Disabled
DHCPv6_SERVER : Disabled
Prompt#
21-77 debug super_vlan state
Description
This command is used to enable or disable the super VLAN Debug Function.
Format
debug super_vlan state [enable | disable]
Parameters
state - Specifies the super VLAN debug function state.
enable - Specifies that the super VLAN debug function will be enabled.
disable - Specifies that the super VLAN debug function will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable the super VLAN Debug Function: