xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
367
DGS-3620-28SC:admin# debug super_vlan state disable
Command: debug super_vlan state disable
Success.
After enabling super VLAN debug, the following information may appear when receive an ARP
packet form sub VLAN.
The ARP request packet received from sub vlan 200.
21-78 debug show address_binding binding_state_table
Description
This command is used to display the binding state of the entries in the binding state table.
Format
debug show address_binding binding_state_table [nd_snooping | dhcpv6_snooping]
Parameters
nd_snooping - Specifies to debug ND Snooping bound addresses in the binding state table.
dhcpv6_snooping - Specifies to debug DHCPv6 Snooping bound addresses in the binding state
table.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the DHCPv6 snooping binding state of entries:
DGS-3620-28SC:admin# debug show address_binding binding_state_table
dhcpv6_snooping
Command: debug show address_binding binding_state_table dhcpv6_snooping
S (State) - S: Start, L: Live, D :Detection, R: Renew, B: Bound
Time - Expiry Time (sec)
IP Address MAC Address S Time Port
--------------------------------------- ----------------- -- ---------- -----
2001:2222:1111:7777:5555:6666:7777:8888 00-00-00-00-00-02 S 50 5
2001::1 00-00-00-00-03-02 B 100 6
Total Entries : 2
To Next Page
Loading...
Need help?
General