D-Link xStack - Page 434

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
429
Format
disable dhcpv6_relay
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the DHCPv6 relay global state to disable:
DGS-3620-28SC:admin# disable dhcpv6_relay
Command: disable dhcpv6_relay
Success.
DGS-3620-28SC:admin#
26-3 config dhcpv6_relay hop_count
Description
Configure the DHCPv6 relay hop_count of the switch.
Format
config dhcpv6_relay hop_count <value 1-32>
Parameters
hop_count - Specifies the number of relay agents that have relayed this message. The default
value is 4.
<value 1-32> - Enter the hop count number here. This value must be between 1 and 32.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the maximum hops of a DHCPv6 relay packet could be transferred to 4: