D-Link xStack - Page 435

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
430
DGS-3620-28SC:admin# config dhcpv6_relay hop_count 4
Command: config dhcpv6_relay hop_count 4
Success.
DGS-3620-28SC:admin#
26-4 config dhcpv6_relay
Description
The command could add/delete an IPv6 address which is a destination to forward (relay) DHCPv6
packets.
Format
config dhcpv6_relay [add | delete] ipif <ipif_name 12> <ipv6addr>
Parameters
add - Add an IPv6 destination to the DHCPv6 relay table.
delete - Delete an IPv6 destination from the DHCPv6 relay table
ipif - The name of the IP interface in which DHCPv6 relay is to be enabled.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
<ipv6addr> - The DHCPv6 server IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add a DHCPv6 server to the relay table:
DGS-3620-28SC:admin# config dhcpv6_relay add ipif System
2001:DB8:1234:0:218:FEFF:FEFB:CC0E
Command: config dhcpv6_relay add ipif System 2001:DB8:1234:0:218:FEFF:FEFB:CC0E
Success.
DGS-3620-28SC:admin#
26-5 config dhcpv6_relay ipif
Description
The command is used to configure the DHCPv6 relay state of one specific interface or all
interfaces.
Format
config dhcpv6_relay ipif [<ipif_name 12> | all] state [enable | disable]