D-Link xStack Reference Guide

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
558
Parameters
<vlan_name 32> - (Optional) Specify the name of the multicast VLAN to be displayed.
If no parameter is specified, the system will display all multicast VLANs.
Restrictions
None.
Example
To display all IGMP snooping multicast VLANs:
DGS-3620-28SC:admin#show igmp_snooping multicast_vlan
Command: show igmp_snooping multicast_vlan
IGMP Multicast VLAN Global State : Disabled
IGMP Multicast VLAN Forward Unmatched : Disabled
VLAN Name :test
VID :100
Member(Untagged) Ports :1
Tagged Member Ports :
Source Ports :3
Untagged Source Ports :
Status :Disabled
Replace Source IP :0.0.0.0
Remap Priority :None
Total Entries: 1
DGS-3620-28SC:admin#
44-13 config igmp_snooping multicast_vlan forward_unmatched
Description
This command is used to configure the forwarding mode for IGMP snooping multicast VLAN
unmatched packets. When the switch receives an IGMP snooping packet, it will match the packet
against the multicast profile to determine which multicast VLAN to associate with. If the packet
does not match all profiles, the packet will be forwarded or dropped based on this setting. By
default, the packet will be dropped.
Format
config igmp_snooping multicast_vlan forward_unmatched [disable | enable]
Parameters
enable - The packet will be flooded on the VLAN.

D-Link xStack Specifications

General

Brand	D-Link
Model	xStack
Category	Switch
Language	English