xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
559
disable - The packet will be dropped.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the forwarding mode for IGMP snooping multicast VLAN unmatched packets:
DGS-3620-28SC:admin#config igmp_snooping multicast_vlan forward_unmatched
enable
Command: config igmp_snooping multicast_vlan forward_unmatched enable
Success.
44-14 config igmp_snooping multicast_vlan auto_assign_vlan
Description
This command is used to enable or disable the assignment of IGMP control packets to the right
ISM VLAN. If auto assign VLAN is enabled, the Switch will check for group matching with multicast
VLAN profiles of which the ingress port belongs to. If there is a match, the result is "in profile" and
the matching multicast VLAN will be set as a packet VLAN. If this function is disabled, the Switch
will do VID checking, and afterwards, if the group does not match the current profile binding, the
Switch will drop this packet.
Format
config igmp_snooping multicast_vlan auto_assign_vlan [enable | disable]
Parameters
enable - Specifies to enable the auto assign VLAN function.
disable - Specifies to disable the auto assign VLAN function.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the auto assign VLAN function of multicast VLAN:
DGS-3620-28SC:admin#config igmp_snooping multicast_vlan auto_assign_vlan enable
Command: config igmp_snooping multicast_vlan auto_assign_vlan enable
Success.
To Next Page
Loading...
Need help?
General