xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
566
<network_address> - Specifies the network address used.
ge - (Optional) Specifies the minimum prefix length to be matched.
<value 1-32> - Enter the 'ge' value used here. This value must be between 1 and 32.
le - (Optional) Specifies the maximum prefix length to be matched.
<value 1-32> - Enter the 'le' value used here. This value must be between 1 and 32.
deny - Specifies that the network will be denied.
permit - Specifies that the network will be permitted.
description - Specifies the description for the prefix list used.
<desc 80> - Enter the description used here. This value can be up to 80 characters long.
clear_description - Specifies that the description for the prefix list will be cleared.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
The following example configures a prefix list 1 to permit routes from the 10.0.0.0/8 network that
have a mask length that is less than or equal to 24 bits:
DGS-3620-28SC:admin# config ip prefix_list 1 add 10.0.0.0/8 le 24 permit
Command: config ip prefix_list 1 add 10.0.0.0/8 le 24 permit
Success.
46-3 delete ip prefix_list
Description
This command is used to delete the IP prefix list
Format
delete ip prefix_list [list_name <list_name 16> | all]
Parameters
list_name - Specifies the prefix list name that will be deleted.
<list_name 16> - Enter the prefix list name that will be deleted here. This name must be 16
characters long.
all - Specifies that all the entries will be deleted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IP prefix list named “list1”:
To Next Page
Loading...
