D-Link xStack

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
583
Example
To set the ECMP hash algorithm:
DGS-3620-28SC:admin# config ecmp algorithm ip_destination ip_source
Command: config ecmp algorithm ip_destination ip_source
Success.
DGS-3620-28SC:admin#
47-10 show ecmp algorithm
Description
This command is used to display the ECMP related settings.
Format
show ecmp algorithm
Parameters
None.
Restrictions
None.
Example
To show current ECMP related settings:
DGS-3620-28SC:admin#show ecmp algorithm
Command: show ecmp algorithm
ECMP for OSPF : Enabled
ECMP Load Balance Algorithm :
Destination IP : used.
Source IP : not used.
CRC_Low : used.
CRC_High : not used.
TCP_UDP_Port : not used.
DGS-3620-28SC:admin#
47-11 create ipv6route redistribute dst ripng src
Description
This command is used to create RIPng route redistribution to import routes from other routing
domain into RIPng routing domain.