D-Link xStack Reference Guide

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
584
Format
create ipv6route redistribute dst ripng src [local | static | ospfv3] {metric <value 0-16>}
Parameters
local - Redistribute local routes into RIPng.
static - Redistribute static routes into RIPng.
ospfv3 - Redistribute OSPFv3 routes into RIPng.
metric - (Optional) Specifies the RIPng route metric for the redistributed routes. When the metric
value is 0, the metric in the original route will become the metric of the redistributed RIPng
route transparently. If the metric of the original route is equal or greater than 16, the route will
be not redistributed.
<value 0-16> - Enter the value between 0 and 16.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To create RIPng route redistribution:
DGS-3620-28SC:admin#create ipv6route redistribute dst ripng src local
Command: create ipv6route redistribute dst ripng src local
Success.
DGS-3620-28SC:admin#
47-12 config ipv6route redistribute dst ripng src
Description
This command is used to configure the metric to be associated with the redistributed routes
imported from a specified protocol to RIPng protocol.
Format
config ipv6route redistribute dst ripng src [local | static | ospfv3] {metric <value 0-16>}
Parameters
local - Redistribute local routes into RIPng.
static - Redistribute static routes into RIPng.
ospfv3 - Redistribute OSPFv3 routes into RIPng.
metric - (Optional) Specifies the RIPng route metric for the redistributed routes. When the metric
value is 0, the metric in the original route will become the metric of the redistributed RIPng
route transparently. If the metric of the original route is equal or greater than 16, the route will
be not redistributed.
<value 0-16> - Enter the value between 0 and 16.

D-Link xStack Specifications

General

Brand	D-Link
Model	xStack
Category	Switch
Language	English