D-Link xStack - Page 649

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
644
DGS-3620-28SC:admin#
51-19 create jwac user
Description
This command creates JWAC users in the local database. When “local” is chosen while
configuring the JWAC RADIUS protocol, the local database will be used.
Format
create jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Enter the user name to be created.
vlan - (Optional) Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication.
<vlanid 1-4094> - Enter the target VLAN ID for the authenticated host which uses this user
account to pass authentication. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a JWAC user in the local DB:
DGS-3620-28SC:admin# create jwac user 112233
Command: create jwac user 112233
Enter a case-sensitive new password:***
Enter the new password again for confirmation:***
Success.
DGS-3620-28SC:admin#
51-20 config jwac user
Description
This command configures a JWAC user.
Format
config jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Enter the user name to be configured.
vlan - (Optional) Specify the target VLAN ID for the authenticated host which uses this user