xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
645
account to pass authentication.
<vlanid 1-4094> - Enter the target VLAN ID for the authenticated host which uses this user
account to pass authentication. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a JWAC user:
DGS-3620-28SC:admin#config jwac user 112233
Command: config jwac user 112233
Enter a old password:***
Enter a case-sensitive new password:***
Enter the new password again for confirmation:***
Success.
51-21 delete jwac
Description
This command is used to delete JWAC users from the local database.
Format
delete jwac [user <username 15> | all_users]
Parameters
user - Specifies the user name to be deleted.
<username 15> - Enter the user name to be deleted. The user name can be up to 15
all_users - Specifies all user accounts in the local database will be deleted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a JWAC user from the local database:
DGS-3620-28SC:admin#delete jwac user 112233
Command: delete jwac user 112233
Success.
To Next Page
Loading...
