D-Link xStack - Page 652

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
647
Restrictions
None.
Example
To display the current JWAC configuration:
DGS-3620-28SC:admin#show jwac
Command: show jwac
State : Disabled
Enabled Ports :
Virtual IP/URL : 0.0.0.0/-
Switch HTTP Port : 80 (HTTP)
UDP Filtering : Enabled
Forcible Logout : Enabled
Redirect State : Enabled
Redirect Delay Time : 1 Seconds
Redirect Destination : Quarantine Server
Quarantine Server :
Q-Server Monitor : Disabled
Q-Server Error Timeout : 30 Seconds
RADIUS Auth-Protocol : PAP
RADIUS Authorization : Enabled
Local Authorization : Enabled
Function Version : 2.11
DGS-3620-28SC:admin#
51-24 show jwac auth_state ports
Description
This command is used to display information for JWAC client hosts.
Format
show jwac auth_state ports {<portlist>}
Parameters
<portlist> - (Optional) Specify a port range to show the JWAC authentication entries.
Note: If no port is specified, the JWAC authentication state will be displayed for all ports.
Restrictions
None.