D-Link xStack - Page 671

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
666
Success.
DGS-3620-28SC:admin#
55-2 config mcast_filter_profile
Description
This command is used to modify the profile name, add or delete a range of previously defined
multicast IP addresses to or from the profile.
Format
config mcast_filter_profile [profile_id <value 1-60> | profile_name <name 32>] {profile_name
<name 32> | [add | delete] <mcast_address_list>}(1)
Parameters
profile_id - Specifies the ID of the profile.
<value 1-60> - The profile ID must be between 1 and 60.
profile_name - Specifies the name of the profile.
<name 32> - The profile name can be up to 32 characters long.
profile_name –Specify a new name of the profile.
<name 32> - The profile name can be up to 32 characters long.
add - Specifies to add a range of multicast IP addresses.
delete - Specifies to delete a range of multicast IP addresses.
<mcast_address_list> - List of the multicast addresses to be added to or deleted from the
profile. Either specifiy a single multicast IP address or a range of multicast addresses
using a hyphen.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add a range of multicast addresses to a profile:
DGS-3620-28SC:admin#config mcast_filter_profile profile_id 2 add 225.1.1.1 –
225.1.1.100
Command: config mcast_filter_profile profile_id 2 add 225.1.1.1 – 225.1.1.100
Success.
DGS-3620-28SC:admin#
55-3 config mcast_filter_profile ipv6
Description
This command is used to add or delete a range of previously defined IPv6 multicast IP addresses
to or from the profile.