D-Link xStack - Page 672

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
667
Format
config mcast_filter_profile ipv6 [profile_id <value 1-60> | profile_name <name 32>]
{profile_name <name 32> | [add | delete] <mcastv6_address_list>}(1)
Parameters
profile_id - Specifies the ID of the profile.
<value 1-60> - The profile ID must be between 1 and 60.
profile_name - Specifies the name of the profile.
<name 32> - The profile name can be up to 32 characters long.
profile_name –Specify a new name of the profile.
<name 32> - The profile name can be up to 32 characters long.
add - Specifies to add a range of multicast IP addresses.
delete - Specifies to delete a range of multicast IP addresses.
<mcastv6_address_list> - List of the IPv6 multicast addresses to be added to or deleted
from the profile. Either specifiy a single IPv6 multicast IP address or a range of IPv6
multicast addresses using a hyphen.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add the IPv6 multicast address range FF0E::100:0:0:20 – FF0E::100:0:0:22 to profile ID 3:
DGS-3620-28SC:admin#config mcast_filter_profile ipv6 profile_id 3 add
FF0E::100:0:0:20 – FF0E::100:0:0:22
Command: config mcast_filter_profile ipv6 profile_id 3 add FF0E::100:0:0:20 –
FF0E::100:0:0:22
Success.
DGS-3620-28SC:admin#
55-4 delete mcast_filter_profile
Description
This command is used to delete a multicast address profile. If the IPv4 or IPv6 option is not
specified, IPv4 is implied.
Format
delete mcast_filter_profile {[ipv4 | ipv6]} [profile_id [<value 1-60> | all] | profile_name <name
32>]
Parameters
ipv4 – (Optional) Specify to delete an IPv4 multicast profile.
ipv6 – (Optional) Specify to delete an IPv6 multicast profile.
profile_id - Specifies the ID of the profile. The range is from 1 to 60.
<value 1-60> - The profile ID must be between 1 and 60.