D-Link xStack - Page 703

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
698
Restrictions
None.
Example
To display LLDP local port information for port 1:
DGS-3620-28SC:admin#show lldp local_ports 1
Command: show lldp local_ports 1
Port ID : 1
-----------------------------------------------------------------------------
Port ID Subtype : MAC Address
Port ID : 00-01-02-03-05-00
Port Description : D-Link DGS-3620-28SC R2.50.014
Port 1 on Unit 1
Port PVID : 1
Management Address Count : 1
PPVID Entries Count : 0
VLAN Name Entries Count : 1
Protocol Identity Entries Count : 0
MAC/PHY Configuration/Status : (See Detail)
Link Aggregation : (See Detail)
Maximum Frame Size : 1536
DGS-3620-28SC:admin#
57-18 show lldp mgt_addr
Description
This command is used to display the LLDP management address.
Format
show lldp mgmt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Parameters
ipv4 - (Optional) Specify the IPv4 address of the LLDP managament address entry.
<ipaddr> - Enter the IPv4 address of the LLDP managament address entry.
ipv6 - (Optional) Specify the IPv6 address of the LLDP managament address entry.
<ipv6addr> - Enter the IPv6 address of the LLDP managament address entry.
Restrictions
None.
Example
To display the LLDP management address: