xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
721
Format
config m
ac_based_
acces
s_control p
orts [
<portlist
> | all]
{stat
e [enabl
e | dis
able] |
aging_time [infinite | <min 1-1440>] | block_time <sec 0-300> | max_users [<value 1-4000> |
no_limit]}(1)
Parameters
<portlist> - Enter a range of ports to configure the MAC-based access control settings
all - Specifies to select all the ports.
state - Specifies whether the MAC-based access control function is enabled or disabled.
enable - Specifies to enable the MAC-based access control function.
disable - Specifies to disable the MAC-based access control function.
aging_time - Specifies a time period during which an authenticated host will be kept in the
authenticated state. When the aging time is timed-out, the host will be moved back to
unauthenticated state.
infinite - Specifies an unlimited aging time.
<min 1-1440> - Enter the age-out time, in minutes, between 1 and 1440.
block_time - Specifies the blocking time, in seconds, between 0 and 300.
<second 0-300> - Enter the blocking time. The blocking time value must be between 0 and
max_users - Specifies the number of maximum users. The default value is 1024 users.
<value 1-4000> - Enter the maximum number of users between 1 and 4000.
no_limit - Specifies an unlimited number of users.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the port state for ports 1 to 8:
DGS-3620-28SC:admin# config mac_based_access_control ports 1-8 state enable
Command: config mac_based_access_control ports 1-8 state enable
Success.
61-7 create mac_based_access_control
Description
This command is used to create a MAC-based access control guest VLAN.
Format
create mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid <vlanid 1-
4094>]
To Next Page
Loading...
