xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
752
Example
To delete an MLD snooping static group from the default VLAN, group FF1E::1:
DGS-3620-28SC:admin#delete mld_snooping static_group vlan default FF1E::1
Command: delete mld_snooping static_group vlan default FF1E::1
Success.
65-7 show mld_snooping static_group
Description
This command is used to display the MLD snooping static groups.
Format
show mld_snooping static_group {[vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>}
Parameters
vlan - (Optional) Specify the name of the VLAN on which the static group resides.
<vlan_name 32> - Enter the VLAN name. The maximum length is 32 characters.
vlanid - (Optional) Specify the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID list.
<ipv6addr> - (Optional) Specify the multicast group IPv6 address.
If no parameter is specified, the system will display all MLD snooping static groups.
If no parameter is specified, the system will display all MLD snooping static groups.
Restrictions
None.
Example
To display all the MLD snooping static groups:
DGS-3620-28SC:admin#show mld_snooping static_group
Command: show mld_snooping static_group
VLAN ID/Name IP Address Static Member Ports
------------- --------------- ---------------------
1/default FF1E::1 9-10
Total Entries : 1
To Next Page
Loading...
Need help?
General