xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
762
Note: If no parameter is specified, the system will display all router ports on the Switch.
Restrictions
None.
Example
To display router ports:
DGS-3620-28SC:admin#show mld_snooping mrouter_ports all
Command: show mld_snooping mrouter_ports all
VLAN Name : default
Static Router Port :
Dynamic Router Port :
Router IP :
Forbidden Router Port :
Total Entries: 1
65-18 show mld_snooping forwarding
Description
This command is used to display the switch’s current MLD snooping forwarding table. It provides
an easy way for users to check the list of ports that the multicast group comes from specific
sources will be forwarded to. The packet comes from the source VLAN. They will be forwarded to
the forwarding ports.
Format
show mld_snooping forwarding {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
Parameters
vlan - (Optional) Specify the name of the VLAN for which to view MLD snooping forwarding table
<vlan_name 32> - Specify the VLAN name. The maximum length is 32 characters.
vlanid - (Optional) Specify the ID of the VLAN for which to view MLD snooping forwarding table
<vlanid_list> - Enter the VLAN ID list.
Note: If no parameter is specified, the system will display all currently configured MLD
snooping forwarding entries.
Restrictions
None.
To Next Page
Loading...
Need help?
General