D-Link xStack - Page 782

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
777
DGS-3620-28SC:admin#show greeting_message
Command: show greeting_message
===============================================================================
DGS-3620-28SC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.50.014
Copyright(C) 2013 D-Link Corporation. All rights reserved.
===============================================================================
DGS-3620-28SC:admin#
67-3 config command_prompt
Description
This command is used to modify the command prompt. The current command prompt consists of
four parts: “product name” + “:” + ”user level” + ”#” (e.g. “DGS-3620-28SC:admin#”). This
command is used to modify the first part (1. “product name”) with a string consisting of a maximum
of 16 characters, or to be replaced with the users’ login user name.
Format
config command_prompt [<string 16> | username | default]
Parameters
<string 16> - Enter the new command prompt string of no more than 16 characters.
username - Specifies the command to set the login username as the command prompt.
default - Specifies the command to return the command prompt to its original factory default
value.