D-Link xStack - Page 799

To Next Page

To Previous Page

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

794

snmp - (Optional) Specify the trusted host for SNMP.

telnet - (Optional) Specify the trusted host for Telnet.

ssh - (Optional) Specify the trusted host for SSH.

http - (Optional) Specify the trusted host for HTTP.

https - (Optional) Specify the trusted host for HTTPs.

ping - (Optional) Specify the trusted host for Ping.

Note: If no management method is specified, the IP (range) can access the Switch

through any method.

Restrictions

Only Administrator and Operator-level users can issue this command.

Example

To create a trusted host:

DGS-3620-28SC:admin#create trusted_host 10.48.74.121

Command: create trusted_host 10.48.74.121

Success.

DGS-3620-28SC:admin#

70-5 config trusted_host

Description

This command is used to configure the access interfaces for the trusted host.

Format

config trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix

<ipv6networkaddr>] [add | delete] {snmp | telnet | ssh | http | https | ping | all}

Parameters

<ipaddr> - Enter the IP address of the trusted host.

<ipv6addr> - Enter the IPv6 address of the trusted host.

network - Specifies the network address of the trusted network. The form of network address is

xxx.xxx.xxx.xxx/y.

<network_address> - Enter the network address of the trusted network. The form of network

address is xxx.xxx.xxx.xxx/y.

ipv6_prefix - Specifies the IPv6 network address of the trusted network.

<ipv6networkaddr> - Enter the IPv6 network address of the trusted network.

add - Allow to manage applications for a trusted host.