D-Link xStack - Page 800

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
795
all - Specifies the trusted host for all applications.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the trusted host:
DGS-3620-28SC:admin#config trusted_host 10.48.74.121 add ssh telnet
Command: config trusted_host 10.48.74.121 add ssh telnet
Success.
DGS-3620-28SC:admin#
70-6 delete trusted_host
Description
This command is used to delete a trusted host entry.
Format
delete trusted_host [ipaddr <ipaddr> | ipv6address <ipv6addr> | network
<network_address> | ipv6_prefix <ipv6networkaddr> | all]
Parameters
ipaddr - Specifies the IP address of the trusted host.
<ipaddr> - Enter the IP address of the trusted host.
ipv6address - Specifies the IPv6 address of the trusted host.
<ipv6addr> - Enter the IPv6 address of the trusted host.
network - Specifies the network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address> - Enter the network address of the trusted network. The form of network
address is xxx.xxx.xxx.xxx/y.
ipv6_prefix - Specifies the IPv6 network address of the trusted network.
<ipv6networkaddr> - Enter the IPv6 network address of the trusted network.
all - Specifies that all trusted hosts will be deleted.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete a trusted host:
DGS-3620-28SC:admin#delete trusted_host ipaddr 10.48.74.121
Command: delete trusted_host ipaddr 10.48.74.121
Success.