D-Link xStack - Page 820

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
815
error - (Optional) Specify severity level 3.
warning - (Optional) Specify severity level 4.
notice - (Optional) Specify severity level 5.
informational - (Optional) Specify severity level 6.
debug - (Optional) Specify severity level 7.
<level_list 0-7> - (Optional) Specify a list of severity levels to be displayed. If more than one
severty level, separate them by comma. The level numbers are from 0 to 7.
module - Specifies the modules to be displayed. The module can be obtained by the show
log_software_module command. Use commas to separate multiple modules.
<module_list> - Enter the modules to be displayed.
Note: If no parameter is specified, all history log entries will be displayed.
Restrictions
None.
Example
To display the switch history log:
DGS-3620-28SC:admin#show log index 1-5
Command: show log index 1-5
Index Date Time Level Log Text
----- ---------- -------- ------- --------------------------------------------
3 2000-03-01 00:26:51 INFO(6) Successful login through Console (Username:
Anonymous)
2 2000-03-01 00:26:49 CRIT(2) System started up
1 2000-03-01 00:26:49 CRIT(2) System warm start
DGS-3620-28SC:admin#
71-9 show log_save_timing
Description
This command is used to display the method to save log.
Format
show log_save_log_timing
Parameters
None.
Restrictions
None.