D-Link xStack - Page 866

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
861
Parameters
ipif - (Optional) Specifies the OSPFv3 IP interface name used.
<ipif_name 12> - Enter the OSPFv3 IP interface name used here. This name can be up to 12
characters long.
all - (Optional) Specifies that all the OSPFv3 IP interfaces will be used.
Restrictions
None. (EI Mode Only Command)
Example
To display OSPFv3 configurations or interfaces information:
DGS-3620-28SC:admin# show ospfv3
Command: show ospfv3
OSPFv3 Router ID: 1.1.1.1
State : Enabled
OSPFv3 Interface Settings
Interface Area ID State Link Metric Instance ID
Status
------------ --------------- -------- --------- --------- -----------
System 0.0.0.0 Disabled Link Up 10 0
Total Entries: 1
OSPFv3 Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost
--------------- ------ ----------------------- -----------------
0.0.0.0 Normal None None
Total Entries: 1
Virtual Interface Configuration
Transit Virtual Hello Dead Instance ID Link
Area ID Neighbor Router Interval Interval Status
--------------- --------------- -------- -------- ----------- ------
Total Entries: 0
OSPFv3 Area Aggregation Settings
Area ID Aggregated LSDB Advertise
Network Address Type
--------------- ------------------------------------------- -------- ---------