D-Link xStack - Page 876

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
871
Parameters
<neighbor_id> - (Optional) Specifies the ID of the neighbor.
ipif - (Optional) Specifies the IP interface where the neighbor is built.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
Restrictions
None. (EI Mode Only Command)
Example
To display OSPFv3 neighbor:
DGS-3620-28SC:admin# show ospfv3 neighbor
Command: show ospfv3 neighbor
Router ID of Interface Neighbor Neighbor
Neighbor Name Priority State
--------------- ------------ -------- -------------
10.10.10.10 System 1 Full
20.20.20.20 ip1 10 Full
Total Entries: 2
DGS-3620-28SC:admin# show ospfv3 neighbor 10.10.10.10 ipif System
Command: show ospfv3 neighbor 10.10.10.10 ipif System
Neighbor ID: 10.10.10.10 Interface Name: System
Neighbor Options: 19 Neighbor Priority: 255
Neighbor State: Full State Changes: 6 times
Interface ID: 1
DGS-3620-28SC:admin#
74-15 show ospfv3 virtual_neighbor
Description
This command is used to display OSPFv3 virtual neighbor information.
Format
show ospfv3 virtual_neighbor {<area_id> <neighbor_id>}
Parameters
<area_id> - (Optional) Specifies the transit area where the virtual neighbor is built.
<neighbor_id> - (Optional) Specifies the ID of the virtual neighbor. If none of the parameters are
set, all the virtual neighbors will be displayed.