D-Link xStack - Page 893

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
888
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all - Specifies that all the IP interfaces will be used.
hello - (Optional) Specifies the time between issuing hello packets to find neighboring routers.
<sec 1-18724> - Enter the hello time value here. This value must be between 1 and 18724
seconds. The default value is 30 seconds.
jp_interval - (Optional) Specifies the interval between transmitting (flooding to all interfaces)
multicast messages to downstream routers, and automatically ‘pruning’ a branch from the
multicast delivery tree. This interval also determines the time interval the router uses to
automatically remove prune information from a branch of a multicast delivery tree and begin to
flood multicast messages to all branches of that delivery tree. These two actions are
equivalent. The default is 60 seconds.
<sec 1-18724> - Enter the join/prune interval value here. This value must be between 1 and
18724 seconds.
state - (Optional) Specifies to allow the PIM function to be disabled or enabled for the above IP
interface. The default is disabled.
enable - Specifies that the PIM function will be enabled.
disable - Specifies that the PIM function will be disabled.
mode - (Optional) Specifies the multicast protocol mode used. – dense mode or sparse mode, or
sm-dm mode. The default value is dense mode.
dm - Specifies that the multicast protocol mode will be set to dense mode.
sm - Specifies that the multicast protocol mode will be set to sparse mode.
sm-dm - Specifies that the multicast protocol mode will be set to sparse-dense mode.
dr_priority - (Optional) Specifies the priority for DR election.
<uint 0-4294967294> - Enter the DR priority value used here. This value must be between 0
and 4294967294. By default, this value is 1.
passive - Specifies whether the interface operates in the PIM passive mode or not.
enable - Specifies that the PIM passive mode will be enabled.
disable - Specifies that the PIM passive mode will be disabled. This is the default option.
register_probe_time - Specifies the register probe time. The default value is 5 sec.
<value 1-127> - Enter the register probe time value here. This value must be between 1 and
127.
register_suppression_time - Specifies the register supression time. The default value is 60 sec.
<value 3-255> - Enter the register suppression time value here. This value must be between 3
and 255.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure PIM configurations of IP interface System:
DGS-3620-28SC:admin# config pim ipif System hello 35 jp_interval 70 state
enable
Command: config pim ipif System hello 35 jp_interval 70 state enable
Success.
DGS-3620-28SC:admin#
77-2 enable pim
Description
This command is used to enable PIM on the switch.