xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
890
77-4 show pim neighbor
Description
This command is used to display the current PIM neighbor router table.
Format
show pim neighbor {ipif <ipif_name 12> | ipaddress <network_address>}
Parameters
ipif - (Optional) Specifies the name of the IP interface for which you want to display the current
PIM neighbor router table.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
ipaddress - (Optional) Specifies the IP address and netmask of the destination.
<network_address> - Enter the destination IP address used here.
If no parameter is specified, the system will display all the PIM neighbor addresses in the table.
Restrictions
None.
Example
To display PIM neighbor address table:
DGS-3620-28SC:admin# show pim neighbor
Command: show pim neighbor
PIM Neighbor Address Table
Interface Name Neighbor Address Expired Time
--------------- ---------------- ------------
System 10.48.74.122 5
Total Entries : 1
77-5 show pim
Description
This command is used to display the current PIM configuration.
Format
show pim {ipif <ipif_name 12>}
To Next Page
Loading...
Need help?
General