D-Link xStack - Page 908

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
903
77-22 show pim-ssm
Description
This command is used to list all PIM-SSM protocol related information.
Format
show pim-ssm
Parameters
None.
Restrictions
None.
Example
To display PIM-SSM state and group range:
DGS-3620-28SC:admin# show pim-ssm
Command: show pim-ssm
SSM Service Model State : Enabled
SSM Group : 232.0.0.0/8
DGS-3620-28SC:admin#
77-23 show pim passive
Description
This command is used to display PIM interface passive mode.
Format
show pim passive {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specifies the IP interface name.
<ipif_name 12> - Enter the IP interface name. This name can be up to 12 characters long.
Restrictions
None.
Example
To display PIM interface passive mode for all interfaces: