xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
902
Example
To list all the RPs of the registered checksum, including the data:
DGS-3620-28SC:admin# show pim register_checksum_include_data_rp_list
Command: show pim register_checksum_include_data_rp_list
PIM Register Checksum Include Data
RP Address
------------------
24.0.0.0
24.1.2.3
Total Entries: 2
77-21 config pim-ssm
Description
This command is used to enable the SSM (Source-Specific Multicast) service model in PIM-SM on
the switch. The PIM-SSM function will take active only when SSM service model and PIM-SM
state both enabled.
Format
config pim-ssm {state [enable | disable] | group_range [default | <network_address>]} (1)
Parameters
state - (Optional) Specifies to enable or disable the SSM service model on the Switch.
enable - Specifies that the SSM service model will be enabled.
disable - Specifies that the SSM service model will be disabled.
group_range - (Optional) Specifies the group address range for the SSM service in IPv4.
default - The default indicates that the group address range is 232.0.0.0/8.
<network_address> - Enter the group address range for the SSM service here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure PIM-SSM state and group range:
DGS-3620-28SC:admin# config pim-ssm state enable group_range default
Command: config pim-ssm state enable group_range default
Success.
To Next Page
Loading...
