D-Link xStack - Page 913

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
908
To show the detailed info of the PIM6 protocol concerned parameters on the interface “System”:
DGS-3620-28SC:admin# show pim6 ipif System
Command: show pim6 ipif System
Interface Name : System
Interface Link-Local Address : FE80::200:FF:FE26:6666
Interface Global Address : 2103::1
PIM6 Mode : SM
State : Enabled
Designated Router : FE80::207:E9FF:FACC
Designated Router Priority : 1
Designated Router Priority Enabled : True
Hello Interval : 30 sec
Triggered Hello Interval : 5 sec
Hello Holdtime : 105 sec
Join Prune Interval : 60 sec
Join Prune Holdtime : 210 sec
LAN Delay Enabled : True
Propagation Delay : 1 sec
Override Interval : 3 sec
Effective Propagation Delay : 1 sec
Effective Override Interval : 3 sec
Join Suppression Enabled : True
Bidirectional Capable : False
BSR Domain Border : Disabled
Stub Interface : Disabled
DGS-3620-28SC:admin#
78-3 config pim6 cbsr
Description
This command is used to set the parameters concerned with the candidate bootstrap router.
Format
config pim6 cbsr {ipif <ipif_name 12> state [enable | disable] | priority <value 0-255> |
hash_masklen <value 0-128>} (1)
Parameters
ipif - (Optional) Specifies the IP interface used in this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
state - (Optional) Specifies whether the input interface can be a C-BSR or not.
enable - Specifies that the input interface will be a C-BSR.
disable - Specifies that the input interface will not be a C-BSR.
priority - (Optional) Specifies the C-BSR priority value.
<value 0-255> - Enter the C-BSR priority value here. This value must be between 0 and 255.
The default value is 64.
hash_masklen - (Optional) Specifies the length (in bits) of the mask. It makes use of a hash
function for the case where a group range has multiple RPs with the same priority.