xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
907
78-2 show pim6
Description
This command is used to display the PIM6 configurations.
Format
show pim6 {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specifies the IP interface to be displayed.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
If no parameter is specified, the system will display the PIM6 parameters on all IPv6 interfaces in
brief.
Restrictions
None. (EI Mode Only Command)
Example
To show the brief info of the PIM6 protocol concerned parameters on all interfaces:
DGS-3620-28SC:admin# show pim6
Command: show pim6
PIM6 Global State : Enabled
Last Hop SPT Switchover : Immediately
Register Probe Interval : 5 sec
Register Suppression Timeout : 60 sec
Keepalive Period : 210 sec
Register Checksum Calculate : Include Data
Embedded RP State : Disabled
PIM6-SM Interface Table
DR Hello J/P BSR
Interface Priority Interval Interval State Border
---------- -------- -------- --------- --------- --------
System 1 3 60 Disabled Disabled
Total Entries : 1
To Next Page
Loading...
Need help?
General