D-Link xStack - Page 916

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
911
Parameters
group - Specifies the IPv6 group address range served by the RP.
<ipv6networkaddr> - Enter the IPv6 network address used here.
rp - Specifies the interface that will act as the C-RP.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To add a multicast group range “FF1E::12EF:1023/64” into the serve list of the C-RP “System”:
DGS-3620-28SC:admin# create pim6 crp group FF1E::12EF:1023/64 rp System
Command: create pim6 crp group FF1E::12EF:1023/64 rp System
Success.
DGS-3620-28SC:admin#
78-7 delete pim6 crp group
Description
This command is used to delete a multicast group range from the C-RP serve list.
Format
delete pim6 crp group <ipv6networkaddr>
Parameters
group - Specifies the multicast group address range of the C-RP entry that wants to be removed
from C-RP serve list.
<ipv6networkaddr> - Enter the IPv6 network address used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To delete a multicast group range “FF1E::12EF:1023/64” from the C-RP serve list:
DGS-3620-28SC:admin# delete pim6 crp group FF1E::12EF:1023/64
Command: delete pim6 crp group FF1E::12EF:1023/64
Success.