D-Link xStack - Page 923

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
918
Format
delete pim6 static_rp group <ipv6networkaddr>
Parameters
group - Specifies the multicast group network address which will be removed from the static RP.
<ipv6networkaddr> - Enter the IPv6 network address used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To delete a static RP:
DGS-3620-28SC:admin# delete pim6 static_rp group FF1E::/64
Command: delete pim6 static_rp group FF1E::/64
Success.
DGS-3620-28SC:admin#
78-15 config pim6 embedded_rp state
Description
This command is used to set the state of the embedded RP.
Format
config pim6 embedded_rp state [enable | disable]
Parameters
state - Specifies the embedded RP support in the PIM6 state.
enable - Specifies that embedded RP support will be enabled.
disable - Specifies that embedded RP support will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To enable the embedded RP state:
DGS-3620-28SC:admin# config pim6 embedded_rp state enable
Command: config pim6 embedded_rp state enable