xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
960
DGS-3620-28SC:admin# config ptp boundary ports all delay_mechanism p2p
Command: config ptp boundary ports all delay_mechanism p2p
Success.
83-9 config ptp p2p_transparent ports
Description
This command is used to configure the pdelay_request message attribute for the message interval
of the P2P transparent clock.
Format
config ptp p2p_
transparent por
ts [<por
tlist> | all
] pdelay_req_inte
rval <sec 1
-32>
Parameters
ports - Specifies the list of port used for this configuration.
<portlist> - Enter the list of port used for this configuration here.
all - Specifies that all the ports will be used for this configuration.
pdelay_req_interval - Specifies the permitted mean time interval between successive
messages.
<sec 1-32> - Enter the permitted mean time interval value used here. This value must be
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the pdelay_req_interval attribute of all the PTP ports to 4 seconds:
DGS-3620-28SC:admin# config ptp p2p_transparent ports all pdelay_req_interval 4
Command: config ptp p2p_transparent ports all pdelay_req_interval 4
Success.
83-10 show ptp
Description
This command is used to display the configured attributes of PTP on the switch.
Format
show ptp
To Next Page
Loading...
Need help?
General