S0602170K
Page 95
Axle (ZF AP 420R)
2. If necessary (according to the Version),
insert hex. head screws into the drive
flange bores and press the dust shield on
the collar of the drive flange.
3. Insert the drive pinion into the axle carrier
and assemble the heated inner bearing
race until contact is obtained.
4. Tighten washer and tighten slotted nut the
required rolling resistance is obtained.
NOTE:
When tightening, make several
full revolutions of the drive
pinion in both directions, and
check the rolling resistance
continuously.
NOTE:
See “Special Tools” on page 15.
5. Loosen slotted nut, tighten drive flange
and remove the pinion again.
Figure 206
Figure 207
Figure 208
To Next Page
Loading...
