S0709665K
Page 29
Flow Amplifier (Danfoss)
CLEANING AND INSPECTION (WEAR LIMITS AND
TOLERANCES)
For general cleaning and inspection procedures, refer to "General Maintenance Procedures" section.
CLEANING
Clean all parts carefully with low aromatic kerosine.
INSPECTION AND REPLACEMENT
Replace all gaskets and sealing washers. Check al other parts carefully and replace if necessary.
LUBRICATION
Before assembly, lubricate all parts with hydraulic oil.
REASSEMBLY
1. Assemble shock valve/suction valve.
A. Guide spring with cone into housing.
Figure 64
To Next Page
Loading...