Daewoo Mega 500-V - Input Shaft (Power Take-Off Pump)

S0607080K
Page 144
Transmission and Torque Converter
(ZF 4WG-310)
INPUT SHAFT (POWER TAKE-OFF PUMP)
1. Tilt gearbox housing 180˚.
2. Squeeze V-rings (3x) into the recess of the
driver (internal splines). Install fitting key
(Figure 361).
3. Adjust Gap Dimension = 0.50 mm (0.0197
in) (Driver/ Input shaft) (Figure 362 -
Figure 366).
A. Line up the disk s = 1.90 mm (0.0748
in) and position inner bearing race
against shoulder.
B. Determine Dimension I from the
inner bearing race to the end face/
driver.
NOTE: Dimension I e.g. 9.64 mm
(0.3795 in).
Reference
Number
Description
1Driver
2 Input Shaft
Figure 361
Figure 362
Figure 363
Figure 364