S0607080K
Page 64
Transmission and Torque Converter
(ZF 4WG-310)
TRANSMISSION PUMP
1. Tilt gearbox housing 180˚.
2. Loosen hex. head screws and remove
both pump flanges.
3. Loosen socket head screws (M8) and
position Puller device (s).
4. Pull transmission pump out of housing
bore
NOTE:
Tapping housing face is a help
during extraction operation.
OUTPUT- LAYSHAFT ASSEMBLY
1. Loosen screw connection and remove
brake caliper.
2. Unlock and loosen hex. head screws, tap
brake disk loose and separate it from
output shaft.
Figure 101
Figure 102
Figure 103
Figure 104
To Next Page
Loading...
