S0607900C
Page 31
Transmission Error Codes (ZF)
F6 ** Clutch Adjustment Data lost.
TCU was not able to read
correct clutch adjustment
parameters.
• Interference during saving
data on non volatile memory.
• TCU is brand new.
No reaction,
Default values = 0 for
AEB offsets used.
OP-Mode: normal.
Execute AEB. ---------------
Fault
Code
(hex)
Meaning of the Fault Code
(Possible reason for fault
detection.)
Reaction of the
TCU
Possible Steps to
Repair
Remarks
* Only Mega 400-III PLUS
** Only Series "V"
Gray shaded boxes are error codes for other applications. They are only given for general reference purposes.
To Next Page
Loading...
