AV7000 LINEAR CAMERA REFERENCE MANUAL
14. Configure the following fields
General Tab
Scan Point Name: Identifies where the scan point is located.
Scan Point address: IP address of the controller unit in the tunnel/array.
Report Category Name: The unique name of the tunnel used for reporting purposes.
Controller Type: select WebSentinel from the drop-down list (subject to change at
release).
Controller Port No: This is the port number set in the scan point scanner.
IP Address: Used for an redundant array only.
Alarm Level: The percentage below which read rates are unacceptable.
Warning Level: The percentage below which read rates are questionable and may
indicate a problem.
Consecutive No-Read Alarm: The number of consecutive no-read conditions allowed
before an alarm is triggered.
Array ControllerTab
Not used for a standard configuration.
To Next Page
Loading...
