Delta DVP-15MC Series User Manual

DVP-15MC Series Motion Controller Operation Manual
11-66
11
1
5. If another MC_MoveSuperimposed instruction is executed when one MC_MoveSuperimposed
instruction controls the axis independently, the previous MC_MoveSuperimposed instruction will be
aborted.
6. If the MC_HaltSuperimposed instruction is executed in the course of execution of
MC_MoveSuperimposed instruction, the MC_MoveSuperimposed instruction will be aborted.
7. MC_MoveSuperimposed can be executed on the slave axis specified by MC_GearIn instruction
and MC_ CamIn instruction.
 Programming Example 1
The programming example is as follows when one MC_MoveSuperimposed instruction is used.
1. The variable table and program
Variable name
Data type
Initial value
Pwr
MC_Power
Axis1
USINT
1
Pwr_En
BOOL
FALSE
Pwr_BM
MC_Buffer_Mode
0
Pwr_Sta
BOOL
Pwr_Bsy
BOOL
Pwr_Act
BOOL
Pwr_Err
BOOL
Pwr_ErrID
WORD
Sup MC_MoveSuperimposed
Sup_Ex
BOOL
FALSE
Sup_Done
BOOL
Sup_Bsy BOOL
Sup_Act
BOOL
Sup_Abt
BOOL
Sup_Err BOOL
Sup_ErrID
WORD
Sup_Distan
LREAL
2
1
Sup_Bsy
Sup_Act
Sup_Abt
Sup_Err
Sup_ErrID
Sup_Done
Sup_Distan
Axis1
5000.0
300.0
100.0
100.0
15.0
Sup_Ex
MC_MoveSuperimposed
Axis Done
Sup
Execute
ContinuousUpdate
Busy
Active
Distance
Error
ErrorID
CommandAborted
Acceleration
Deceleration
Jerk
Velocity
CoveredDistance
Axis1
True
True
Pwr_BM
Pwr_Bsy
Pwr_Act
Pwr_Err
Pwr_ErrID
Pwr_En
Pwr_Sta
MC_Power
Axis Status
Pwr
Enable
EnablePositive
Busy
Active
EnableNegative
BufferMode
Error
ErrorID

Delta DVP-15MC Series Specifications

General

Brand	Delta
Model	DVP-15MC Series
Category	Controller
Language	English