Delta DVP-15MC Series User Manual

Chapter 12 Troubleshooting
12-11
1
2
ErrorID
Meaning How to deal with
Hex
Decimal
the software.
1044 4164
The cam curve specified by
MC_CamIn is not built in the
software.
Check if the CamTable value of MC_CamIn
can correspond to the cam curve built in the
software.
1045 4165 Axis group ID error
Check if the value of GroupID is within the
range of 1~8.
1046 4166 Mode input value error
The value of Mode for the instruction can
only be set to 0
1047 4167
The number of the From/To
instruction is wrong.
Check the value of Station and the number of
the instruction are correct.
1048 4168
An error in the number of CR
registers which are read and
written by From/To.
Check if the value of Num
is within the range
of 1~64.
1049 4169
The variable is not set for an
instruction input pin
Set an variable for the input pin.
104A 4170
No response transmitted to
From/To instruction
Check if the connection between modules is
proper and if the extension module works
normally.
104B 4171 Empty CNC file
Check if the value of NCFile is correct and the
corresponding CNC file is empty.
104C 4172 Path resolution error
Ensure that the G codes or axes group
instructions settings for the path are correct.
104D 4173
The position capture instruction
did not receive the capture signal
within the window range and the
capture failed.
Ensure that the window range is set properly.
104E 4174
G code identifying error
Ensure that G code file writing is proper.
104F
4175
Incorrect pre-read G code format
Ensure that G code file writing is proper.
1050
4176
G-code pre-reading error
Ensure that G code file writing is proper.
1051
4177
Path writing error
Ensure that path writing is proper.
1052 4178
The setting for Position of the axis
drive specified in MC_Home
instruction failed. Perhaps the
drive does not support the
parameter.
Check if the drive supports the parameter
Position.
1053 4179
MC_Home instruction does not
support the encoder axis which
takes data sources as the encoder
mode and SSI absolute encoder
axis.
Modify the axis type into other axis type.
1054 4180
Too many levels of G26 nesting in
G codes
Check if the number of levels of G26 nesting
exceeds 16.
2001 8193
The axis is disabled by means of
MC_Power instruction when it is
not in Standstill state.
Make the axis disabled by using MC_Power
instruction when the axis is in Standstill
state.
2002 8194
The instruction cannot be
executed due to the limitation of
the motion direction.
Set EnablePositive and EnableNegative of
MC_Power to TRUE to cancel the limitation
of the motion direction of the axis.

Delta DVP-15MC Series Specifications

General

Brand	Delta
Model	DVP-15MC Series
Category	Controller
Language	English