Delta DVP-15MC Series - Page 900

DVP-15MC Series Motion Controller Operation Manual
12-22
12
1
System error code
Explanation Correction
Hexadecimal
Decimal
3026 12326 Watchdog timeout
Check if the program is correct or there is a
loop of which the program execution can not
get out when the program execution timeout
occurs.
3027 12327
Calling the axis state machine
failed.
Contact local technicians if the error still exists
after re
downloading the program and restoring
to the factory setting.
3028 12328 CNC list analysis error
Check if the CNC file is correct and
redownload the program.
3029 12329 CNC file analysis error
Check if the CNC file is correct and
redownload the program.
302A 12330 Cam file parsing failed.
Check if the cam file is correct. Contact local
technicians if the problem still exists after re-
downloading the program.
3031 12337 Source code file parsing failed.
Check if the source code file is correct.
Contact local technicians if the problem still
exists after re-downloading the program.
3050 12368
The actual time for executing the
priority 0 task exceeds the set
watchdog timeout time.
Contact local distributors
3051 12369
The actual time for executing the
priority 1 task exceeds the set
watchdog timeout time.
1. Reset the watchdog time to a larger
value for the task.
2. Check whether there is any infinite loop
in the program which the task calls.
3. Redownload it after modifying the
program.
3052 12370
The actual time for executing the
priority2 task exceeds the set
watchdog timeout time.
1. Reset the watchdog time to a larger
value for the task.
2. Check whether there is any infinite loop
in the program which the task calls.
3. Redownload it after modifying the
program.
3053 12371
The actual time for executing the
priority 3 task exceeds the set
watchdog timeout time.
1. Reset the watchdog time to a larger
value for the task.
2. Check whether there is any infinite loop
in the program which the task calls.
3. Redownload it after modifying the
program.
3054 12372
The actual time for executing the
priority 4 task exceeds the set
watchdog timeout time.
1. Reset the watchdog time to a larger
value for the task.
2. Check whether there is any infinite loop
in the program which the task calls.
3. Redownload it after modifying the
program.
3055 12373
The actual time for executing the
priority
5 task exceeds the set
watchdog timeout time.
1. Reset the watchdog time to a larger
value for the task.
2. Check whether there is any infinite loop
in the program which the task calls.
3.
Redownload it after modifying the
program.
3056 12374
The actual time for
executing the
priority 6 task exceeds the set
watchdog timeout time.
1. Reset the watchdog time to a larger
value for the task.
2. Check whether there is any infinite loop
in the program which the task calls.