Warning
• Friction calibration must be performed with a temperature of at least 40 ℃ (313 K) or higher
throughout warm-up for each axis of the robot. Doosan Robotics does not assume responsibility
for any robot motion problems or various other issues caused by failing to comply with this
condition.
12.14 KT Smart Factory Setting Screen
This screen sets the KT Smart Factory function.
1 Tap the Settings button and select KT Smart Factory.
2 Enter values according to the validation of each item.
3 Items required are IP address, port value, Device ID, Device Password, Gateway ID and
transmission frequency.
4 Pressing the Confirm button applies the entered values.
To Next Page
Loading...
