Note
• Safe Stop 1 (SS1) is set as the default stop mode for the Emergency Stop button.
• If additional Emergency Stop buttons are needed, a button can be added to the Controller after a
risk assessment.
• Emergency stop must not be used as a safeguard, but as a complementary protection
measure.
• If additional Emergency Stop buttons are needed, an application risk assessment must be
performed. The Emergency Stop button must comply with IEC 60947-5-5.
• If an emergency stop occurred through the port set at Safety I/O, the button capable of accessing
the screen for Safety Input setting at the bottom of the emergency stop popup window is enabled.
To Next Page
Loading...
