Edge-Core ECS4620-28F - Page 1076

Chapter 8 | Authentication Commands
RADIUS Client
– 246 –
auth-port - RADIUS server UDP port used for authentication messages.
(Range: 1-65535)
key - Encryption key used to authenticate logon access for client. Do not
use blank spaces in the string. (Maximum length: 48 characters)
retransmit - Number of times the switch will try to authenticate logon
access via the RADIUS server. (Range: 1-30)
timeout - Number of seconds the switch waits for a reply before resending
a request. (Range: 1-65535)
Default Setting
auth-port - 1812
acct-port - 1813
timeout - 5 seconds
retransmit - 2
Command Mode
Global Configuration
Example
Console(config)#radius-server 1 host 192.168.1.20 port 181 timeout 10
retransmit 5 key green
Console(config)#
radius-server key This command sets the RADIUS encryption key. Use the no form to restore the
default.
Syntax
radius-server key key-string
no radius-server key
key-string - Encryption key used to authenticate logon access for client. Do
not use blank spaces in the string. (Maximum length: 48 characters)
Default Setting
None
Command Mode
Global Configuration
Example
Console(config)#radius-server key green
Console(config)#